FCC Information
This device complies with Part 15 of the FCC Rules, operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
This equipment complies with the limits for a Class B digital device as specified in Part 15 of FCC Rules. These limits
provide reasonable protection against radio and TV interference in a residential area.
However, your equipment might cause TV or radio interference even when it is operating properly. To eliminate interference
you can try one or more of the following corrective measures:
• Reorient or relocate the receiving antenna.
• Increase the distance between the equipment and the radio or TV.
• Use outlets on different electrical circuits for the equipment and the radio or TV.
• Consult your dealer or an experienced radio/television technician if the problem still exists.
Modifying or tampering with your system’s internal components can cause a malfunction and might invalidate the system’s
warranty and void your FCC authorization to operate it.
This Class B digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.
Battery Information
For Models Requiring More Than One Battery
• Do not mix with used or other battery types/brands
• Replace all cells at the same time
• Do not open batteries
• Do not heat above 75ºC (167ºF)
• Do not expose contents to water
• Do not charge or recharge
• Do not install backwards
• Do not dispose of in fire
iP37 Quick Start
1:batteries
2:AC adaptor
Open battery compartment located inside unit. Insert 4
“AA” batteries (not included) as indicated on diagram.
Unit can now play iPod/iPhone. Batteries will not charge
iPod/iPhone.
Connect AC adaptor to the DC jack (left of iP37) and plug
the other end into a working wall socket to charge and play
iPod/iPhone. Does not charge batteries.
iPod nano 5G
insert 18
iPod touch 2G
insert 16
iPhone 3G
Use this insert
insert 15
For this
iPhone/iPod
iPhone 3G
iPod touch 2G
iPod nano 5G
NOTE: If you do not have an insert for your iPhone/iPod, please visit
3:inserts
4:iPod/iPhone
Select the dock insert for your iPod/iPhone model from the
table above and place insert in dock.
Gently place iPod/iPhone on the connector plug in dock.
Press the Power Button. Unit and iPod/iPhone will turn
on. Adjust volume by pressing the + or – Button.
Never dock an iPod/iPhone without an insert in place.
1
Controls and Indicators
Front Panel
Speakers
Battery Compartment
Dock
Volume “+”
(raises volume)
_
Power On/Off Button
Volume “ ”
(lowers volume)
Side Panel
AC Adaptor Jack
Line-in Jack
2
Getting Started
Thank you for purchasing the iHome iP37 Portable Speaker System for your iPhone and iPod. Designed specifically to work
with your iPhone and iPod, this system provides high quality audio performance that invites your music to come out and play.
Please read this instruction book carefully before the unit is operated and keep it for future reference.
Install iPhone/iPod Insert
Your iP37 comes with 3 removable inserts to ensure your iPhone/iPod fits properly in the
Dock. Please see table on page 1 to select your insert.
Place iPhone/iPod Insert
Connect to Power
Connect AC Adaptor
Connect the AC adaptor cable plug into the jack on the left of the unit, then plug the AC
RESET
R E S E T
TEST
adaptor into the wall outlet. When connected to the AC adaptor, the iP37 charges your
iPhone/iPod. The adaptor does not charge AA batteries.
Note: This iPhone/iPod does NOT charge when the iP37 is operating on batteries. This AC
adaptor is for use with the iP37 only. To avoid damage, do not use iP37 with other adaptor.
Connect AC Adaptor
Install/Replace Speaker Batteries
We recommend the use of alkaline batteries for longer life.
Different types of batteries or new and used batteries are not to be mixed.
1. Press on the two battery door locking tabs to remove the battery door.
2. Insert 4 “AA” batteries (not included) as indicated on the diagram and
replace the battery door.
Battery Compartment
Unit can now play iPhone or iPod. Batteries will not charge iPhone or iPod.
3
Playing and Charging your iPhone or iPod
1. Place proper insert for your iPhone/iPod (see insert table on page 1) in Dock, then gently dock iPhone/iPod. When docked
and connected to AC power, the iPhone/iPod will charge until fully charged. The unit will not charge iPhone or iPod
when operating on batteries.The iPhone/iPod will not overcharge.
2. Press the
3. Press the + or – Button to adjust unit volume.
4. To switch off the unit, press the Button once more. It will switch off both iP37 and your iPhone/iPod.
Button to play iPhone/iPod and the button will light up to show iP37 is on.
Using the Line-in Jack
audio device and the other end of the patch cord into the iP37 Line-in Jack.
2. Press the
iP37 is on.
Button to turn the unit on and begin playback on your external audio device.The button will light up to show
3. Press the + or – Button Volume to adjust the volume. You may need to adjust your device’s volume too.
4. To switch off the unit, just press the Button again. Remember to switch off your device too.
NOTE: Do not connect and play an audio device to the line-in jack while playing an iPhone or iPod in the dock or you will
hear both sound sources at once.
4
A Consumer Guide to Product Safety
When used in the directed manner, this unit has been designed and manufactured to ensure your personal safety. However,
improper use can result in potential electrical shock or fire hazards. Please read all safety and operating instructions carefully
before installation and use, and keep these instructions handy for future reference. Take special note of all warnings listed in
these instructions and on the unit.
1. Water and Moisture – The unit should not be used near water. For example: near a bathtub, washbowl, kitchen sink,
laundry tub, swimming pool or in a wet basement.
2. Ventilation – The unit should be situated so that its location or position does not interfere with its proper ventilation. For
example, it should not be situated on a bed, sofa, rug or similar surface that may block ventilation openings. Also, it
should not be placed in a built-in installation, such as a bookcase or cabinet, which may impede the flow of air through
the ventilation openings.
3. Heat – The unit should be situated away from heat sources such as radiators, heat registers, stoves or other appliances
(including amplifiers) that produce heat.
4. Power Sources – The unit should be connected to a power supply only of the type described in the operating instructions
or as marked on the appliance.
5. Power-Cable Protection – Power supply cables should be routed so that they are not likely to be walked on or pinched
by items placed upon or against them. It is always best to have a clear area from where the cable exits the unit to where
it is plugged into an AC socket.
6. Cleaning – The unit should be cleaned only as recommended. See the Maintenance section of this manual for cleaning
instructions.
7. Objects and Liquid Entry – Care should be taken so that objects do not fall and liquids are not spilled into any openings
or vents located on the product.
8. Attachments – Do not use attachments not recommended by the product manufacturer.
9. Lightning and Power Surge Protection – Unplug the unit from the wall socket and disconnect the antenna or cable
system during a lightning storm or when it is left unattended and unused for long periods of time. This will prevent damage
to the product due to lightning and power-line surges.
10. Overloading – Do not overload wall sockets, extension cords, or integral convenience receptacles as this can result in
a risk of fire or electric shock.
11. Damage Requiring Service – The unit should be serviced by qualified service personnel when:
A. the power supply cable or plug has been damaged.
B. objects have fallen into or liquid has been spilled into the enclosure.
C. the unit has been exposed to rain.
D. the unit has been dropped or the enclosure damaged.
E. the unit exhibits a marked change in performance or does not operate normally.
12. Periods of Nonuse – If the unit is to be left unused for an extended period of time, such as a month or longer, the power
cable should be unplugged from the unit to prevent damage or corrosion.
13. Servicing – The user should not attempt to service the unit beyond those methods described in the user’s operating
instructions. Service methods not covered in the operating instructions should be referred to qualified service personnel.
5
Trouble Shooting
Symptom
Possible Problem
Solution
Unit doesn’t respond
(no power)
AC adaptor isn’t plugged into a wall outlet
or the connector is not plugged into the
power supply jack on the back of the dock
Plug the AC adaptor into a wall outlet and plug the
connector into the supply jack on the unit
Plug another device into the same outlet to confirm the outlet
is working. Make sure any associated power switch is ON
Wall outlet is not functioning or switched off
Batteries are weak or dead
Replace with new batteries
iPod/iPhone does not
dock properly
Using no or wrong iPod/iPhone insert
iPod/iPhone not docked properly
Make sure the dock insert is the proper fit for your iPod/iPhone
Remove your iPod/iPhone from the dock and check for
obstruction on the connectors in the dock and on your
iPod/iPhone. Make sure there is no “skin” or case on the
iPod/iPhone. Then reseat it in the dock.
iPod/iPhone does
not respond to the
unit
Remove your iPod/iPhone from the dock and check for
obstruction on the connectors in the dock and on your
iPod. Then reseat it in the dock.
iPod/iPhone is not docked properly
Upgrade software on your iPod/iPhone via iTunes
Your iPod/iPhone software is too old
iPod/iPhone is locked up
Please make sure your iPod/iPhone is working properly
before docking into the unit. Please refer to your
iPod/iPhone manual for details.
Using 1st or 2nd generation iPod, iPod
shuffle or other devices.
Unit cannot control those iPod models or other devices.
Use the Line-in jack to play these devices.
iPod/iPhone does not
come on immediately
If your iPod/iPhone is not used for some
time, it may enter deep sleep mode
Press the Menu button on your iPod/iPhone
Charge your iPod/iPhone for about 5 minutes
iPod/iPhone battery is run down or is too weak
6
Limited 1 Year Warranty Information
iHome Products, a division of SDI Technologies Inc. (hereafter referred to as SDI Technologies), warrants this product to be free from defects
in workmanship and materials, under normal use and conditions, for a period of 1 year from the date of original purchase.
Should this product fail to function in a satisfactory manner, it is best to first return it to the store where it was originally purchased. Should this
fail to resolve the matter and service still be required by reason of any defect or malfunction during the warranty period, SDI Technologies will
repair or, at its discretion, replace this product without charge (except for a $10.00 charge for handling, packing, return UPS/postage, and
insurance). This decision is subject to verification of the defect or malfunction upon delivery of this product to the Factory Service Center listed
below. The product must include proof of purchase, including date of purchase. The fee for service without proof of purchase is $30.00.
Before returning this product for service, please first replace the batteries (if applicable) with fresh ones, as exhausted or defective batteries are
the most common cause of problems encountered.
If service is still required:
1. Remove the batteries (if applicable) and pack the unit in a well padded, heavy corrugated box.
2. Enclose a photocopy of your sales receipt, credit card statement, or other proof of the date of purchase, if within the warranty period.
3. Enclose a check or money order payable to the order of SDI Technologies, for the sum of $10.00 ($30.00 without proof of purchase).
4. Send the unit prepaid and insured, to the Factory Service Center listed below.
Consumer Repair Department
SDI Technologies Inc.
1330 Goodyear Drive
El Paso, TX 79936-6420
Disclaimer of Warranty
NOTE: This warranty is valid only if the product is used for the purpose for which it was designed. It does not cover (i) products which have
been damaged by negligence or willful actions, misuse or accident, or which have been modified or repaired by unauthorized persons; (ii)
cracked or broken cabinets, or units damaged by excessive heat; (iii) damage to digital media players, CD’s or tape cassettes (if applicable); (iv)
the cost of shipping this product to the Factory Service Center and its return to the owner.
This warranty is valid only in the United States of America and does not extend to owners of the product other than to the original purchaser.
In no event will SDI Technologies or any of its affiliates, contractors, resellers, their officers, directors, shareholders, members or agents be liable
to you or any third party for any consequential or incidental damages, any lost profits, actual, exemplary or punitive damages. (Some states do
not allow limitations on implied warranties or exclusion of consequential damages, so these restrictions may not apply to you.) This warranty
gives you specific legal rights, and you may also have other rights which vary from state to state.
Your acknowledgement and agreement to fully and completely abide by the above mentioned disclaimer of warranty is contractually binding
to you upon your transfer of currency (money order, cashier's check, or credit card) for purchase of your SDI Technologies product.
© 2009 SDI Technologies, Inc. All rights reserved
or call 1-800-288-2792 Toll Free
7
iP37-120709-A
Printed in China
|