INSTALLATION INSTRUCTIONS FOR PART 99-7300
APPLICATIONS
HYUNDAI Tiburon 1997-2002
HYUNDAI Accent 2000-2001
99-7300
KIT FEATURES
• ISO Mount Radio Provision
KIT COMPONENTS
A) Radio Housing 1 • B) Bracket Set 1 • C) (2) #10 x 3/4” Phillips Screws • D) Radio Housing 2
• E) Bracket Set 2 • F) (4) #10 x 3/4” Phillips Pan Headed Screws
A
C
B
D
E
F
TOOLS REQUIRED:
Phillips Screwdriver • Panel Removal Tool
1-800-221-0932
© COPYRIGHT 2004-2007 METRA ELECTRONICS CORPORATION
99-7300 DASH DISASSEMBLY
HYUNDAI Tiburon 1997-2002
A
1
2
Disconnect the negative battery ter-
minal to prevent an accidental short
circuit.
Remove (4) Phillips screws securing
the center console. Pry out on the
front edge of the console and unclip
the radio trim bezel. Remove (4)
Phillips screws securing the factory
head unit and disconnect the wiring.
(Figure A)
Continue to final assembly.
1
99-7300 DASH DISASSEMBLY
HYUNDAI Accent 2000-2001
A
1
2
Disconnect the negative battery ter-
minal to prevent an accidental short
circuit.
Open the cupholder and remove (2)
Phillips screws exposed. Lower the
glove box and detach the vent cable
exposed. Reach under the driver's
side dash and detach the vent cable
exposed. Reach under the driver's
side dash and detach (2) vent cables
located above the accelerator. Unclip
the dash trim bezel and remove.
Remove (4) screws securing the fac-
tory head unit and disconnect the
wiring. (Figure A)
Continue to final assembly.
2
99-7300 KIT ASSEMBLY
HYUNDAI TIBURON ISO MOUNT
RADIO PROVISION WITH POCKET
*Note: Refer also to the instructions included with the aftermarket radio.
1
2
Snap the ISO Brackets over the mount-
ing tabs on the Radio Housing.
(Figure A)
A
Slide the head unit into the Radio
Housing, align the holes in the head
unit with the holes in the Housing and
mount the unit with the screws supplied
with the unit. (Figure B)
Continue to final assembly.
B
3
99-7300 KIT ASSEMBLY
HYUNDAI ACCENT ISO MOUNT RADIO PROVISION
*Note: Refer also to the instructions included with the aftermarket radio.
A
1
2
Snap the ISO Brackets over the
mounting tabs on the Radio Housing.
(Figure A)
Slide the head unit into the Radio
Housing, align the holes in the head
unit with the holes in the Housing and
mount the unit with the screws sup-
plied with the unit. (Figure B)
Continue to final assembly.
B
4
99-7300 FINAL ASSEMBLY
FINAL ASSEMBLY
A
B
(A) Strip wire ends back 1/2"
B) Twist ends together
C) Solder
D) Tape
C
D
Locate the factory wiring harness in the dash. Metra recommends using the
proper mating adapter and making connections as shown. (Isolate and individ-
ually tape off the ends of any unused wires to prevent electrical short circuit.)
1
2
3
Re-connect the negative battery terminal and test the unit for proper operation.
Reassemble radio and dash assemblies in reverse order of disassembly.
*NOTE:
*NOTE: To mount Radio Housing assembly in Tiburon use (2) factory screws removed during
disassembly and (2) #10 X 3/4” Phillips screws supplied with this kit.
FINAL WIRING CONNECTIONS
Make wiring connections using the EIA color code chart shown below and the instructions included with the
head unit. Metra recommends making connections as shown below; Strip, Splice, Solder, Tape. Isolate and
individually tape off ends of any unused wires to prevent electrical short circuit.
METRA / EIA WIRING CODE
12V Ignition / Acc. . . . . . . . . . Red
Right Front (+) . . . . . . . . . . . . Gray
12V Batt / Memory. . . . . . . . . Yellow
Ground. . . . . . . . . . . . . . . . . . Black*
Power Antenna. . . . . . . . . . . . Blue
Right Front (-). . . . . . . . . . . . . Gray/ Black
Left Front (+) . . . . . . . . . . . . . White
Left Front (-). . . . . . . . . . . . . . White / Black
Right Rear (+) . . . . . . . . . . . . Violet
Amp Turn-On . . . . . . . . . . . . . Blue / White
Amp Ground. . . . . . . . . . . . . . Black / White
Illumination . . . . . . . . . . . . . . Orange
Dimmer . . . . . . . . . . . . . . . . . Orange / White
Right Rear (-) . . . . . . . . . . . . . Violet / Black
Left Rear (+) . . . . . . . . . . . . . Green
Left Rear (-) . . . . . . . . . . . . . . Green / Black
*NOTE:
*NOTE: When a Black wire is not present, ground radio to vehicle chassis.
All colors may not be present on all leads due to manufacturer’s specifications.
5
99-7300 INSTRUCTIONS
1-800-221-0932
REV. 08/24/07 © COPYRIGHT 2004-2007 METRA ELECTRONICS CORPORATION INST99-7300
|