Havis Shields Work Light KK RLL User Manual

INSTALLATION INSTRUCTIONS KK-RLL

ROOF MOUNTED LOAD LIGHT

TOOLS REQUIRED:

Power drill

Caulk gun with silicone

3/8” drill bit

Safety goggles

Wrench set

HARDWARE SUPPLIED:

Work Light with Double Lamp

5/16 -18 x 1” Stainless Hex Head Bolt

5/16-18 Nylock Nut

5/16” x 1 ½” Fender Washer

3/8” Plastic Grommet

Light mounting Bracket

HE-90600B

GSM34010

GSM30017

GSM31019

GSM20003

PRM97310

INSTALLATION INSTRUCTIONS:

Note: Mounting and wiring must be done prior to prisoner compartment installation.

Bolt light fixture to the mounting bracket. (End with 2” flange and one hole).

Overall bracket size is 10 ½” long by 2” wide.

Position load light bracket in desired location on roof: Recommended location is

to center light above door opening on side or rear of van. If there is a third brake

light, position the work light over the third brake light not on top of light.

Mark and drill three (3) 3/8” diameter holes. Bolt the bracket assembly on with

two (2) stainless steel 5/16-18 x 1” bolts, nuts and fender washers.

The 3^rd3/8” diameter hole is for the wire. Wire goes through the roof and the

bracket. Insert 3/8” plastic grommet in the hole from inside van going outside.

Run wire through the bracket and grommet. Silicone the hole.

Follow the attached wiring diagram for the standard 3-way switching included in

kit. This gives the option of turning light on from the cab of the vehicle or the

rear or side doors.

Note: See attached wiring diagram.

Note: If desired, light can be activated with a single pole single throw switch in the dash.

H:\KwKit\KK-RLL-INST-4-05.doc