Havis Shields Automobile Parts P REAR 2 User Manual

INSTALLATION INSTRUCTIONS P-REAR-2

REAR PARTITION w/ EXIT HATCH

1997-2008 FORD E-SERIES VANS

**WILL NOT WORK IN 2008 15 PASSENGER VAN (NO SPACE)**

TOOLS REQUIRED:

Power Drill

Drill Bit Set

3/8” Socket Set

Eye Protection

Ratcheting Wrench

HARDWARE:

QTY

DESCRIPTION

PART #

5/16” x 1 ½” Hex Head Lag Bolt

¼-20 x 1” Hex Head Bolt

¼” Flat Washer

¼-20 Serrated Nut

Top Mounting Brackets

GSM33066

GSM33002

GSM31005

GSM30023

HS-PA99008-1

1. INSTALLATION:

• Rear passenger seat will remain in place. There is very little space between seat and rear

doors.

• Place and position partition w/ spring clips facing towards rear of vehicle.

• Partition must be pushed tight against seat in order to close doors.

• Drill 3/16” pilot holes into floor of vehicle.

• Bolt partition to vehicle using 5/16” x 1 ½” Hex head lag bolts.

• Loosely bolt Top-mounting brackets to partition w/ (2) ¼-20 x 1” Hex Head bolt, washer,

and nut.

• Mark and pre-drill 3/16” pilot where bracket lands on vehicles rear door trim. Attach

using (4) 5/16” x 1 ½” Hex head lag bolts.

• Tighten all loose hardware

Top Mounting

Bracket Locations

P-REAR-2_INST_9-07