Havis Shields Automobile Accessories C TM IMP User Manual

INSTALL INSTRUCTIONS C-TM-IMP

2000-2005 CHEVROLET IMPALA TRAK-MOUNT KIT

TOOLS REQUIRED:

Ratcheting Wrench

Metric Socket Set

Torx Bit Set

Standard Socket Set

Tape Measure

HARDWARE:

QTY DESCRIPTION

PART#

¼” x ¾” hex head bolt

¼” Serrated nut

¼” x 1” Hex head lag bolts

32” Trak mount

GSM33001

GSM30023

GSM33060

CM93055-9

SUB ASSEMBLY:

1. MOUNT TRAK TO HUMP BRACKETS.

• Determine location that Trak will land on transmission hump for the specific

application.

• With Trak in necessary location, measure Front and Rear Hump Brackets in relation

to Trak.

• Bolt Trak to Hump Brackets, using measurements taken in previous step

Note: There are 2 different sides to the Trak Plate. It is recommended to mount Hump brackets

to side of Trak Plate that has ¼” hardware slots closer together, to better accept equipment,

(consoles, control heads, etc)

• Slide (6) ¼-20 x ¾” Hex Head Bolts into ¼” Hardware Slots.

• With bolts in Trak, position Hump brackets.

• There is a left and right side to the Rear Hump Brackets. Top of brackets will be

parallel to the transmission hump.

• Attach ¼” serrated nuts and tighten.

TRAK-MOUNT ASSEMBLY

(Image Upside down)

Front Hump Bracket C-B17

Rear Hump Bracket C-B27

¼” Hardware Slots

Trak