Grizzly Network Router G1026 User Manual

G1705 & G1794 Router Bit Spindle

For The G1035 & G1026 Shapers

To install the router bit spindle, proceed as follows:

Remove existing spindle from the shaper by holding the top of the spindle with a wrench and

remove the tie rod nut from the bottom of the spindle housing. Figure 2. Pull the spindle out of

the spindle cartridge. Notice that the bottom portion of the spindle is identical to the bottom por-

tion of the router bit spindle.

Unthread the tie rod from

the spindle and completely

thread into the bottom of the

router bit spindle.

⁄

2'' TO ¹⁄4'' Adapter

Tie Rod

Place the router bit spindle

into the spindle housing and

line up the pin with the key-

way. Figure 3. Tighten the

tie rod nut to secure. Use a

back-up wrench on the

router bit spindle while tight-

ening the tie rod nut.

Collet Nut

Tie Rod Nut

Figure 2. Draw Bar & Nut.

Figure 1. Router Bit Spindle.

Keyway

Place a router bit into the router bit spindle and

tighten the collet nut.

Router Bit Spindle

Caution: Do not run the router bit spindle in reverse

direction (clockwise if you look down on the spidle).This

can cause the collet nut to loosen, allowing the router bit

to come out.

Spindle Cartridge

Spindle Housing

Figure 3. Inserting Router Bit Spindle.